Western Telematic MT5634 manual Command \Nn Error Correction Mode Selection

MT5634 Modem; AT Command Set

Command: \Nn	Error Correction Mode Selection
Values:	n = 0–5, or 7
Default:	3
Description:	\N0	Non-error correction mode with data buffering
		(buffer mode; same as &Q6).
	\N1	Direct mode.
	\N2	MNP reliable mode. If the modem cannot make an
		MNP connection, it disconnects.
	\N3	V.42/MNP auto-reliable mode. The modem attempts first
		to connect in V.42 error correction mode, then in MNP
		mode, and finally in non-error correction (buffer) mode
		with continued operation.
	\N4	V.42 reliable mode. If the modem cannot make a V.42
		connection, it disconnects.
	\N5	V.42, MNP, or non-error correction (same as \ N3).
	\N7	V.42, MNP, or non-error correction (same as \ N3).

Command: \Qn	Flow Control Selection
Values:	n = 0, 1, or 3
Default:	3	Disable flow control (same as &K0).
Description:	\Q0
	\Q1	XON/XOFF software flow control (same as &K4).
	\Q2	CTS-only flow control. Not supported.
	\Q3	RTS/CTS hardware flow control (same as &K3).

Command: \Tn	Inactivity Timer
Values:	n = 0, 1–255
Default:	0
Description:	Sets the time (in minutes) after the last character is sent or
	received that the modem waits before disconnecting. A value of
	zero disables the timer. Applies only in buffer mode.
	Note: You can also set the inactivity timer by changing the
	value of S30.

Command: \Vn	Protocol Result Code
Values:	n = 0, 1, or 2
Default:	1
Description:	\V0	Disables the appending of the protocol result code to
		the DCE speed.
	\V1	Enables the appending of the protocol result code to
		the DCE speed.
	\V2	Same as \V1.

3-10