MT5634 Modem; AT Command Set
Command: %DCn AT Command Control
Values: |
| n = 0 or 1 | |
Default: |
| 0 |
|
Description: |
| %DC0 | The modem responds to AT commands. |
|
| %DC1 | The modem ignores AT commands. |
|
| Note: The modem will respond to AT%DC for 10 seconds | |
|
| after | |
Command: | %En | Fallback and Fall Forward Control | |
Values: |
| n = 0, 1, or 2 | |
Default: |
| 2 |
|
Description: |
| %E0 | Disable fallback and fall forward. |
|
| %E1 | Enable fallback, disable fall forward. |
|
| %E2 | Enable fallback and fall forward. |
Command: %Hn Direct Connect Enable | |||
Values: |
| n = 0, 1 |
|
Default: |
| 0 |
|
Description: |
| %H0 | Sets callback security to normal operation. |
|
| %H1 | All callback security calls will be direct connect |
|
|
| regardless of whether the password or phone number |
|
|
| has the - character. |
Command: | %Rn | Cisco Configuration | |
Values: |
| n = 0, 1 |
|
Default: |
| 0 |
|
Description: |
| %R0 | Disables Cisco configuration. |
|
| %R1 | Sets E0, Q1, &D0, \N0, $SB9600, and %S1 for |
|
|
| operation with a Cisco router. |
Command: %Sn | Command Speed Response | ||
Values: |
| n = 0, 1 |
|
Default: |
| 0 |
|
Description: |
| %S0 | Sets modem to respond to AT commands at all |
|
|
| normal speeds. |
|
| %S1 | AT commands accepted at 115200 bps only. |
|
|
| Commands at other speeds are ignored. |
Command: | $Dn | DTR Dialing | |
Values: |
| n = 0 or 1 | |
Default: |
| 0 |
|
Description: |
| $D0 | Disables DTR dialing. |
|
| $D1 | Dials the number in memory location 0 when |
|
|
| DTR goes high. |