Teledyne 2101 installation and operation guide Safety Connecting To Flowlink

2101 Field Wizard

Section 2 Preparation and Installation

2.2 Safety

2.3Connecting To Flowlink

WARNING

Avoid hazardous practices! If you use these instruments in any way not specified in this manual, the protection provided by the instruments may be impaired; this will increase your risk of injury.

WARNING

The installation and use of this product may subject you to hazardous working conditions that can cause you serious or fatal injuries. Take any necessary precautions before entering a worksite. Install and operate this product in accordance with all applicable safety and health regulations, and local ordinances.

The 2100 Series components are often installed in confined spaces. Some examples of confined spaces include manholes, pipelines, digesters, and storage tanks. These spaces may become hazardous environments that can prove fatal for those unpre- pared. These spaces are governed by OSHA 1910.146 and require a permit before entering.

Before you use your Field Wizard in the field to collect data, you need to synchronize it to Isco’s Flowlink software on a personal computer (PC).

Use the following instructions to connect to Flowlink for the first time. More detailed information about transferring data to Flowlink can be found in Section 3.3.

Use Isco’s communication cable P/N 60-2004-046 and AC Adapter (P/N 60-2004-057) to connect the Field Wizard to a PC, as shown in Figures 2-1 and 2-2.

Uncap the communication connector on the underside of the Field Wizard, and store the connector cap in its holder. Then plug the AC Adapter into the communication connector, as shown in Figure 2-1. Plug the other end of the AC Adapter into a grounded electrical outlet.

2-2