Teledyne 2101 installation and operation guide Unlocking

2101 Field Wizard

Section 2 Preparation and Installation

2.4.1Latches - Locking and Latches must be operated to stack and unstack the modules in a

Unlocking	Series 2100 stack. The mechanisms are the same for the Field
	Wizard and other 2100 Series modules. Take a moment to famil-
	iarize yourself with operating the latches. The latch is operated
	by pushing on one of the sides — the right side to unlock, and the
	left side to lock.

CAUTION

The latch can be damaged by applying too much force. Never press on both sides at the same time. Do not force the latch if it is obstructed. While some degree of pressure must be applied to slide the latch, the ends of the latches should never bend more than 1/8".

L’attache peut-être endommagée en la forçant. Ne jamais presser simultanément des deux côtés à la fois. Ne pas forcer en cas de résistance. Ne jamais tordre les extrémités des attaches de plus de 3 mm.

Figure 2-4 shows how to unlock the latch. You must unlock the latch to place the module on top of a stack. Otherwise, the latch is normally locked.

Figure 2-5 shows how to lock the latch.

Note

Latches will “click” when they are fully locked and unlocked.

2-5