Vantec UGT-ST310R user manual For Windows XP/Server

Page 16

to Windows.

2.At Found New Hardware Wizard, click Next.

3.Select Search for a suitable driver for my device (recommend) then click Next.

4.Insert the driver CD, check CD-ROM drives, uncheck the other boxes, click Next, then click Next again.

5.If the Digital Signature Not Found message appears, click Yes. Our driver has been thoroughly tested for stability and compatibility.

6.Click Finish.

7.Repeat steps 2-6.

8.Restart Windows to complete the driver installation.

For Windows® XP/Server 2003

For A New Installation

A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the “UGT-ST310R\2000_XP_2003_Vista\32bit” folder, found on the driver CD, onto a blank floppy disk then follow the directions below.

1.Setup the RAID Array prior to Windows installation.

2.Follow Microsoft’s Windows installation procedure.

3.At the Windows Setup screen, press F6 to install the RAID driver.

4.When prompted, press S to specify the location of the driver.

5.Insert the floppy disk, then press Enter.

6.Select Silicon Image SiI 3114 SoftRAID 5 Controller for Windows XP/Server 2003, then press Enter.

7.Press Enter to finish driver installation, then follow the on- screen instructions to complete the Windows installation.

UGT-ST310R

Page 16

Page 15 Page 17
Image 16
Page 15 Page 17
Contents Port Sata II 150 PCI Host Card w/RAID Table of Contents Package Contents ConnectorsBus Interface System Requirements Hardware DescriptionHardware Installation Device ConnectionAuto configuration recommended Size, Manual Configuration is offeredConfiguration RAID ArraysSelect Auto configuration, then press Enter Manual configurationSelect Manual configuration then press Enter Select Manual configuration, then press Enter RAID 1 Mirror For New/Blank Hard DrivesFor Existing Hard Drives with Data Select Create with data copy, then press EnterWhen asked Are you sure to exitY/N?, press Y to exit Rebuilding a Failed Mirror SetRAID 0+1 Mirroring + Striping Select Create RAID Set then press EnterAuto configuration recommended Enter RAID 5 ParitySelect Create without data copy then press Enter When asked Are you sure to exitY/N?, press Y to exit Concatenation Jbod Deleting RAID ArraysLow Level Format Resolving ConflictsLogical Drive Info Driver Installation Bios ConfigurationFor Windows For Windows XP/Server For Windows XP-x64/Server For Windows Vista To Verify Windows Installation For Windows Vista-x64For Windows 2000/XP/Server 2003/Vista Sata RAID 5 Management Software InstallationFor Windows XP-x64/Server 2003-x64/Vista-x64
Top Page Image Contents