Vantec UGT-ST310R user manual Hardware Installation, Device Connection

Note: There are six SATA ports in 6-Port SATA II 150 PCI Host Card w/RAID. We name these ports from A through F. Ports A to D are internal SATA ports. Ports E and F are external SATA ports. Changing the jumper settings allows you to select between external and internal ports to use. By default, Port A, B, C and D are working.

Hardware Installation

1.Turn Off the power to your computer and any other connected peripheral devices.

2.Unplug the power cord form the back of the computer.

3.Remove your computer’s cover.

4.Remove the slot bracket from an available PCI slot.

5.To install the card, carefully align the card’s bus connector with the selected PCI slot on the motherboard. Push the board down firmly, but gently, until it is well seated.

6.Replace the slot bracket’s holding screw to secure the card.

Device Connection

The 6-Port SATA II 150 PCI Host Card w/RAID is a four channel Serial ATA controller that supports up to four Serial ATA hard disk drives. It is recommended to use identical hard drives for all RAID configurations.

1.Install your hard disk drive(s) in chassis.

2.Connect the Serial ATA hard disk drive to the system power supply using the included Serial ATA power cable.

3.Connect one end of the Serial ATA cable to the hard disk

UGT-ST310R Page 5