Vantec UGT-ST310R user manual For Windows XP-x64/Server

Page 17

For An Existing Installation

1.Setup the RAID Array prior to driver installation and boot up to Windows.

2.At the Found New Hardware Wizard, select No, not this time, then click Next.

3.Insert the driver CD, select Install the software automatically (Recommended), and click Next.

4.Click Finish.

5.Restart Windows to complete the driver installation.

For Windows® XP-x64/Server 2003-x64

For A New Installation

A new installation requires a floppy disk for the driver installation. To make this floppy disk, copy the contents of the “UGT-ST310R\XP_2003_Vista\64bit” folder, found on the driver CD, onto a blank floppy disk then follow the directions below.

1.Setup the RAID Array prior to Windows installation.

2.Follow Microsoft’s Windows installation procedure.

3.At the Windows Setup screen, press F6 to install the RAID driver.

4.When prompted, press S to specify the location of the driver.

5.Insert the floppy disk, then press Enter.

6.Select Silicon Image SiI 3114 SoftRAID 5 Controller (64- bit Extended), then press Enter.

7.Press Enter to finish driver installation, then follow the on- screen instructions to complete the Windows installation.

For An Existing Installation

UGT-ST310R

Page 17

Page 16 Page 18
Image 17
Page 16 Page 18
Contents Port Sata II 150 PCI Host Card w/RAID Table of Contents Bus Interface ConnectorsPackage Contents Hardware Description System RequirementsDevice Connection Hardware InstallationSize, Manual Configuration is offered Auto configuration recommendedConfiguration RAID ArraysSelect Manual configuration then press Enter Manual configurationSelect Auto configuration, then press Enter RAID 1 Mirror For New/Blank Hard Drives Select Manual configuration, then press EnterFor Existing Hard Drives with Data Select Create with data copy, then press EnterRebuilding a Failed Mirror Set When asked Are you sure to exitY/N?, press Y to exitRAID 0+1 Mirroring + Striping Select Create RAID Set then press EnterAuto configuration recommended Select Create without data copy then press Enter RAID 5 ParityEnter When asked Are you sure to exitY/N?, press Y to exit Deleting RAID Arrays Concatenation JbodLogical Drive Info Resolving ConflictsLow Level Format For Windows Bios ConfigurationDriver Installation For Windows XP/Server For Windows XP-x64/Server For Windows Vista For Windows Vista-x64 To Verify Windows InstallationFor Windows XP-x64/Server 2003-x64/Vista-x64 Sata RAID 5 Management Software InstallationFor Windows 2000/XP/Server 2003/Vista
Top Page Image Contents