use existing hard drive(s) with data. To create a RAID 0+1 set four hard drives are required.
Auto configuration (recommended)
The default chunk size is 64k when selecting Auto
configuration.
1.As the BIOS boots press Ctrl+S or F4 when prompted to enter the RAID BIOS.
2.At the next screen select Create RAID Set, then press Enter.
3.Select RAID10, then press Enter.
4.Select Auto configuration, then press Enter.
5.Input the RAID size, press Enter.
6.When asked Are You Sure(Y/N)?, press Y to accept.
7.Press Ctrl+E to exit the BIOS.
8.When asked Are you sure to exit(Y/N)?, press Y to exit and reboot.
9.Continue with FDISK and FORMAT steps as if you were installing a conventional hard drive.
Manual configuration
1.As the BIOS boots press Ctrl+S or F4 when prompted to enter the RAID BIOS.
2.At the next screen select Create RAID Set, then press Enter.
3.Select RAID10, then press Enter.
4.Select the number of drives then press Enter.
5.Select Manual configuration then press Enter.
Page 10 |