UNICOM Electric GST-2402 specifications LED Indicators, Rear Panel

Page 10

LED Indicators

The LED Indicators give real-time information of systematic operation status.

The following table provides a description of LED status.

Figure 2-2. LED indicators

LED	Status	Description

	Green	Power On
Power
	Off	Power is not connected

	Green	The port is connecting with the device.

LNK/ACT	Blinks	The port is receiving or transmitting data.

	Off	No device attached.

	Orange	The port is operating in Full-duplex mode.

FDX/COL	Blinks	Collision of Packets occurs in the port.

	Off	in half-duplex mode

	Table 2-1. The Description of LED Indicators

Rear Panel

Image 10

Contents SmartGST-2402 Introduction Appendix Introduction SmartGST-2402Features Software Features Package Contents Ethernet Switching TechnologyPage Hardware Description Front PanelLED Indicators Rear PanelDesktop Installation Attaching Rubber FeetRack-mounted Installation Attach mounting brackets with screwsPower On Mounting the Switch in an EIA standard 19 RackNetwork Application Small WorkgroupSegment Bridge Small Workgroup ApplicationConnecting to the Switch Department Bridge ApplicationLogin in the Console Interface Console ManagementTrunk Configuration configure Trunk function Main MenuControl Key description Port Configuration Port StatusTrunk Configuration Trunk Status QoS Priority Tag Insert/Remove SystemVlan Member Setup Add Vlan GroupDelete Vlan Group Save Incorrect connections TroubleshootingFaulty or loose cables Non-standard cablesDiagnosing LED Indicators CablingTechnical Specification Power Appendix Console Port Pin AssignmentsCables Cable Types and Specifications Max. Length Connector100BASE-TX/10BASE-T Pin Assignments Pin MDI-X Signal Name MDI Signal Name RJ-45 Pin Assignments Pin Number