UNICOM Electric GST-2402 specifications Power On, Mounting the Switch in an EIA standard 19 Rack

Page 13

Figure 2-5. Mounting the Switch in an EIA standard 19" Rack

Note: For proper ventilation, allow about at least 4" (10 cm) of clearance on the front and 3.4" (8 cm) on the back of the Switch. This is especially important for enclosed rack installations.

Power On

Connect the power cord to the power socket on the rear panel of the Switch. The other side of power cord connects to the power outlet. The internal power supply of the Switch works with voltage range of AC in the 100-240VAC, frequency 50~60Hz.

Check the power indicator on the front panel to see if power is properly supplied.

Image 13

Contents SmartGST-2402 Introduction Appendix SmartGST-2402 IntroductionFeatures Software Features Ethernet Switching Technology Package ContentsPage Front Panel Hardware DescriptionRear Panel LED IndicatorsAttaching Rubber Feet Desktop InstallationAttach mounting brackets with screws Rack-mounted InstallationMounting the Switch in an EIA standard 19 Rack Power OnSmall Workgroup Network ApplicationSmall Workgroup Application Segment BridgeDepartment Bridge Application Connecting to the SwitchConsole Management Login in the Console InterfaceMain Menu Trunk Configuration configure Trunk functionControl Key description Port Status Port ConfigurationTrunk Configuration Trunk Status QoS System Priority Tag Insert/RemoveAdd Vlan Group Vlan Member SetupDelete Vlan Group Save Faulty or loose cables TroubleshootingIncorrect connections Non-standard cablesCabling Diagnosing LED IndicatorsTechnical Specification Power Console Port Pin Assignments AppendixCables Cable Types and Specifications Max. Length Connector100BASE-TX/10BASE-T Pin Assignments RJ-45 Pin Assignments Pin Number Pin MDI-X Signal Name MDI Signal Name