Perle Systems C-110-XXXXX, CM-110-XXXXX manual Duplex copper Switch Switch Position Mode

Page 8

Duplex (copper) (Switch 4)

Switch Position

Mode

 

 

Up (default)

Full

 

 

Down

Half

 

 

Note: When Auto Negotiation (SW1) is set to Off, the Media Converter will use this Duplex setting for its copper connection.

Up: The Media Converter Module will be set to Full Duplex mode.

Down: The Media Converter Module will be set to Half Duplex mode.

Speed (copper) (Switch 5)

Switch Position Mode

Up (default)

100

 

 

Down

10

Note: When Auto Negotiation (SW1) is set to Off, the Media Converter Module will use this Speed setting for its Ethernet copper connection.

Up: The Media Converter will be fixed at 100 Mbps.

Down: The Media Converter will be fixed at 10 Mbps.

8

Perle 10/100 Media Converter Module – Installation Guide

Image 8
Contents CM-110-XXXXX Overview Installation Auto-MDIX JumperAuto-Config Jumper CM-110 only DIP Switches DIP Switch Settings Auto Negotiation Switch Switch Position ModeLink Mode Switch Switch Position Far End Fault Switch Switch Position ModePerle 10/100 Media Converter Module Installation Guide Duplex copper Switch Switch Position Mode Speed copper Switch Switch Position ModeDuplex fiber Switch Switch Position Mode Loopback SwitchInstalling or Replacing Media Converter Modules Installing or Replacing a Media Converter ModuleInstalling the Duplex Fiber Cable Installing the Copper Cable Operation Status LEDPause Ieee 802.3xy Error RecoveryAuto-MDIX Troubleshooting GeneralNo connectivity MethodMethod Technical Specifications Fiber Cabling Requirements Ethernet Copper Cabling RequirementsEN 55022, Class a EN 55024, Class a Laser Safety IEC Compliance InformationCopyright Warranty / RegistrationContacting Technical Support