Perle Systems C-110-XXXXX, CM-110-XXXXX manual Installing the Copper Cable

Page 12

∙Connect the fiber cable from one Media Converter Module to the other Media Converter/switch/fiber device.

Installing the Copper Cable

∙Locate 10/100Base-T compliant copper cables with male, RJ- 45 connectors installed at both ends.

∙Connect the RJ-45 cable between the Perle Media Converter Module and the device.

Note: The Perle Media Converter Module supports Auto-MDIX which allows a straight-through or cross-over Ethernet cable. See page 4 in this guide for jumper positions.

12	Perle 10/100 Media Converter Module – Installation Guide

Image 12

Contents CM-110-XXXXX Overview Installation Auto-MDIX JumperAuto-Config Jumper CM-110 only DIP Switches DIP Switch Settings Auto Negotiation Switch Switch Position ModeLink Mode Switch Switch Position Far End Fault Switch Switch Position ModePerle 10/100 Media Converter Module Installation Guide Duplex copper Switch Switch Position Mode Speed copper Switch Switch Position ModeDuplex fiber Switch Switch Position Mode Loopback SwitchInstalling or Replacing Media Converter Modules Installing or Replacing a Media Converter ModuleInstalling the Duplex Fiber Cable Installing the Copper Cable Operation Status LEDError Recovery Auto-MDIXPause Ieee 802.3xy Troubleshooting GeneralNo connectivity MethodMethod Technical Specifications Fiber Cabling Requirements Ethernet Copper Cabling RequirementsEN 55022, Class a EN 55024, Class a Laser Safety IEC Compliance InformationWarranty / Registration Contacting Technical SupportCopyright