Perle Systems DS1, TS2 manual Set Modbus-Slave Line, Set Modbus-Master Line, Ipaddress, Host, Port

Line Service Commands

<ip_address>

Specify the IP address of the remote host that is receiving the vmodem connection.

<host>

Select the hostname (from the host table) of the remote host that is receiving the vmodem connection.

<port>

Specify the TCP port that the remote host is listening on for the vmodem connection.

delete

Deletes the specified entry from the phone number table.

Set Modbus-Slave Line

Description	Sets the Modbus slave parameters for the line.
User Level	Admin
Syntax	set modbus-slave line .<number>* [crlf onoff]
	[protocol rtuascii] [uid-range <uid_range>]
Options	crlf
	When Modbus/ASCII is selected, adds a CR/LF to the end of the transmission; most
	Modbus devices require this option. The default is On.
	protocol
	Specify the protocol that is used between the Modbus Master(s) and Modbus Slave(s),
	either RTU or ASCII.
	uid-range
	You can specify a range of UIDs (1-247), in addition to individual UIDs. The format is
	comma delimited; for example, 2-35, 50, 100-103.

Set Modbus-Master Line

Description	Sets the Modbus master parameters for the line.
User Level	Admin
Syntax	set modbus-master line .<number>* [crlf onoff]
	[protocol rtuascii]
	[[entry <number> [port <port>] [protocol udptcp]
	[range-mode gatewayhost] [slave-ip <IP_address>]
	[uid-range <start_uid> <end_uid>]]

Options crlf

When Modbus/ASCII is selected, adds a CR/LF to the end of the transmission; most

Modbus devices require this option. The default is On.

protocol

Specify the protocol that is used between the Modbus Master(s) and Modbus Slave(s), either RTU or ASCII.

entry

You can specify up to 16 Modbus Slave Remote IP Mapping entries (the UIDs must not overlap).

50