Perle Systems TS2, DS1 manual Network Commands Chapter, Snmp Commands, Add Community, Add Trap

5 Network Commands Chapter 5

This chapter defines all the CLI commands associated with configuring the IOLAN’s network parameters.

SNMP Commands

The IOLAN supports SNMP traps for restart and SNMP community authentication error.

Add Community

Description	Adds an SNMP community (version 1 and version 2).
User Level	Admin
Syntax	add community <community_name> <config_host><ip_address>
	nonereadonlyreadwrite
Options	<community_name>
	A name that will be sent to the IOLAN from an SNMP manager. This name will define
	the permissions of the manager.
	<config_host><ip_address>
	The host name of the SNMP community that will send requests to the IOLAN.
	The IPv4 or IPv6 address of the SNMP manager that will send requests to the IOLAN.
	If the address is 0.0.0.0, any SNMP manager with the Community Name can access
	the IOLAN. If you specify a network address, for example 172.16.0.0, any SNMP
	manager within the local network with the Community Name can access the IOLAN.
	nonereadonlyreadwrite

Permits the IOLAN to respond to SNMP requests by:

zNone—There is no response to requests from SNMP.

zReadonly—Responds only to Read requests from SNMP.

zReadwrite—Responds to both Read and Write requests from SNMP.

Add Trap

Description	Adds an SNMP host to which trap messages will be sent.
User Level	Admin
Syntax	add trap <community> <config_host><ip_address> <version> <type>
Options	<community>
	This is the community name associated with this trap. The host who will receive the
	traps must belong to the same SNMP community.

IOLAN DS1/TS2 CLI Reference Guide, Version 4.5 57