Perle Systems DS1, TS2 manual Set IOChannel Analog True Analog, Options analogchannel

Set IOChannel

active-to-inactive-delay

When the I/O is commanded to an inactive state, this is the length of the delay before the command is executed. Valid values are 1-9999 x 100 ms. The default is 100 ms.

inactive-to-active-delay

When the I/O is commanded to an active state, this is the length of the delay before the command is executed. Valid values are 1-9999 x 100 ms. The default is 100 ms.

active-signal-width

How long the channel output will be active during the pulse mode. Valid values are 1-9999 x 100 ms. The default is 100 ms.

inactive-signal-width

How long the channel output will remain inactive during pulse mode. Valid values are 1-9999 x 100 ms. The default is 100 ms.

failsafe-action

When there has been no I/O activity within the specified time (set in the Global

Settings) and the Failsafe Timer is triggered, you can set the Failsafe Action to:

zNone—The state of the Digital/Relay output remains the same, no change.

zActivate Output—Activates the output.

zDeactivate Output—Deactivates the output.

Set IOChannel Analog (True Analog)

Description Sets the Analog input channel settings.

User Level Admin

Syntax set iochannel <analog_channel> type currentvoltage range <range_specifier>

set iochannel <analog_channel> alarm

[level 12345 [mode onoff] [trigger-type disabledlowhigh] [trigger-level <decimal_value>] [clear-mode automanual] [clear-level <decimal_value>] [snmp onoff] [syslog onoff]]

Options analog_channel

Specify the Analog channel number, for example, a2 or a4 (this also applies to

Temperature models).

type

Select the type of input being measured, either Current or Voltage. The default is

Current.

range

Select the range for the measurement type. For current, the range is:

z0-20 (0-20mA) This is the default.

z4-20 (04-20mA)

For voltage, the range is:

z1 (+/-1V)

z5 (+/-5V)

z10 (+/-10V) This is the default.

z150 (+/-150mV)

z500 (+/-500mV)

80