LED Designations, Port LEDs | NETGEAR GS752TXS specs

GS752TXS Smart Switch Hardware Installation Guide

•Four dedicated 1000 Mbps/10Gbps SFP+ Gigabit Ethernet switching ports. Up to two of these ports (ports 51 and 52) can alternatively be used as stacking ports.

•Reset button to restart the device

•Recessed default reset button to restore the device back to the factory defaults

•Link, Speed, and Activity LEDs for each port

•Power, Fan Status, Stack Master, and Stack ID LEDs

Figure 3 illustrates the NETGEAR GS752TXS Smart Switch back panel.

Power Connector

Figure 3. Back Panel

The back panel contains a power connector.

LED Designations

Port LEDs

The following table describes the RJ-45 and dedicated SFP port LED designations. There are two LEDs for each RJ-45 port. Each SFP port has its own indication LED.

LED	Designation

Link/Speed/ACT LED mode for	• Off—No link established.
copper ports 1 to 48	• Solid Green—A valid 1000 Mbps link is established.
	• Blinking Green—The port is transmitting or receiving packets at
	1000 Mbps.
	• Solid Yellow—A valid 10/100 Mbps link is established.
	• Blinking Yellow—The port is transmitting or receiving packets
	at 10/100 Mbps.

Link/ACT LED for SFP+ ports	• Off—No SFP+ module link is established
49 to 52	• Solid Green—A valid 10 Gbps link is established.
	• Blinking Green— The port is transmitting or receiving packets
	at 10 Gbps.
	• Solid Yellow—A valid 1000Mbps link is established on the port.
	• Blinking Yellow—The port is transmitting or receiving packets at
	1000 Mbps

Chapter 2. Physical Description 13