NETGEAR GS752TXS manual European Union

Page 34

GS752TXS Smart Switch Hardware Installation Guide

FCC Radio Frequency Interference Warnings & Instructions

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following methods:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the receiver.

Connect the equipment into an electrical outlet on a circuit different from that which the radio receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.

Modifications made to the product, unless expressly approved by NETGEAR, Inc., could void the user's right to operate the equipment.

Canadian Department of Communications Radio Interference Regulations

This digital apparatus, GS752TXS Smart Switch, does not exceed the Class B limits for radio-noise emissions from digital apparatus as set out in the Radio Interference Regulations of the Canadian Department of Communications.

European Union

The GS752TXS Smart Switch complies with essential requirements of EU EMC Directive 2004/108/EC and Low Voltage Directive 2006/95/EC as supported by applying the following test methods and standards:

EN55022: 2006 / A1: 2007

EN55024: 1998 / A1: 2001 / A2: 2003

EN60950-1: 2005 2nd Edition

EN 61000-3-2:2006

EN 61000-3-3:1995 w/A1: 2001+A2: 2005

GPL License Agreement

GPL may be included in this product; to view the GPL license agreement go to ftp://downloads.netgear.com/files/GPLnotice.pdf.

For GNU General Public License (GPL) related information, please visit

http://support.netgear.com/app/answers/detail/a_id/2649 .

34 Appendix : Notification of Compliance

Image 34
Contents GS752TXS Smart Switch Technical Support Table of Contents GS752TXS Smart Switch Hardware Installation Guide GS752TXS Smart Switch Hardware Installation Guide Contents Introduction Features OverviewStacking Package Contents GS752TXS Smart Switch Hardware Installation Guide Page GS752TXS Front-Panel and Back-Panel Configuration Physical DescriptionLED Designations Port LEDsSystem LEDs Following table describes the system LED designationsRJ-45 Ports Device Hardware InterfacesSFP+ Ports Reset Button Factory Defaults ButtonPage Desktop Switching ApplicationsBackbone Switching Backbone Switching ApplicationsInstallation Installing the Switch in a Rack Installing the SwitchInstalling the Switch on a Flat Surface Preparing the SiteChecking the Installation Connecting Devices to the SwitchInstalling an SFP Transceiver Module Connecting Devices to the SwitchInstalling Device as Stand-alone or Stack Master Installing and SFP Transceiver ModuleApplying AC Power Stacking TopologiesManaging the Switch using a Web Browser or the PC Utility Troubleshooting Troubleshooting ChartSwitch Integrity Additional Troubleshooting SuggestionsConfiguration Network Adapter CardsTechnical Specifications Interface Physical Specifications Page Netgear Wired Products Notification of ComplianceEuropean Union Index Index