NETGEAR Official Installation Manual for the Smart Switch

Page 16

GS752TXS Smart Switch Hardware Installation Guide

Reset Button

The Smart Switch has a Reset button on the front panel to allow you to manually reboot the switch. This action is equivalent to powering the unit off and back on. The last saved configuration is loaded into the switch as it resets. To operate the Reset button, insert a device such as a paper clip into the opening to press the recessed button. The front-panel LEDs should extinguish and light again as the switch performs its Power On Self Test (POST).

Factory Defaults Button

The Smart Switch has a Factory Defaults button on the front panel so that you can remove the current configuration and return the device to its factory settings. When you enable the Factory Defaults button, all settings including the password, VLAN settings, and port configurations are removed. To operate the Factory Defaults button, insert a device such as a paper clip into the opening to press the recessed button for over two seconds.

Note: Switches that are part of stack will retain the stacking configuration.

16 Chapter 2. Physical Description

Image 16
Contents GS752TXS Smart Switch Technical Support Table of Contents GS752TXS Smart Switch Hardware Installation Guide GS752TXS Smart Switch Hardware Installation Guide Contents Introduction Features OverviewStacking Package Contents GS752TXS Smart Switch Hardware Installation Guide Page GS752TXS Front-Panel and Back-Panel Configuration Physical DescriptionLED Designations Port LEDsSystem LEDs Following table describes the system LED designationsRJ-45 Ports Device Hardware InterfacesSFP+ Ports Reset Button Factory Defaults ButtonPage Desktop Switching ApplicationsBackbone Switching Backbone Switching ApplicationsInstallation Installing the Switch Installing the Switch on a Flat SurfaceInstalling the Switch in a Rack Preparing the SiteChecking the Installation Connecting Devices to the SwitchInstalling an SFP Transceiver Module Connecting Devices to the SwitchInstalling Device as Stand-alone or Stack Master Installing and SFP Transceiver ModuleApplying AC Power Stacking TopologiesManaging the Switch using a Web Browser or the PC Utility Troubleshooting Troubleshooting ChartAdditional Troubleshooting Suggestions ConfigurationSwitch Integrity Network Adapter CardsTechnical Specifications Interface Physical Specifications Page Netgear Wired Products Notification of ComplianceEuropean Union Index Index