Adjusting the treble, Setting high pass filter

Basic Operations

3-1. Push the [P.CH] button upward or downward to adjust the gain, the FREQ (center frequency) and the Q.

BASS GAIN: +7 to –7 (The factory default setting is “0”)

BASS FREQ: 50Hz/80Hz/120Hz (The factory default setting is “50”)

BASS Q: 1/1.25/1.5/2 (The factory default setting is “1”)

3-2. Press the [					] button to return to the

previous mode.

●Adjusting the treble

The treble gain and treble FREQ (center frequency) can be adjusted as follows.

The adjustment can only be performed when the DZE is set to “DZE OFF”.

2-1. Select “TREBLE”.

2-2. Press the [ ] button.

2-3. Push the [SEEK PANEL] leftward or rightward and select from:

“TREB GAIN” ↔ “TREB FREQ”

3-1. Push the [P.CH] button upward or downward to adjust the gain and FREQ (center frequency).

TREB GAIN: +6 to –6 (The factory default setting is “0”)

TREB FREQ: 8KHz/12KHz (The factory default setting is “12K”)

3-2. Press the [					] button to return to the

previous mode.

●Adjusting the sound restorer

The sound restorer enriches the playback of all types of music files that have undergone any level of data compression.

2-1. Select “S RESTORER”.

3-1. Push the [P.CH] button upward or downward to adjust.

Each time you push the [P.CH] button, the sound restorer changes in the following order:

“OFF” ↔ “1” ↔ “2” ↔ “3”

∗The factory default setting is “OFF”.

Set this adjustment in accordance with the music source used

OFF: For music sources compressed at high bit rate

1:For music sources compressed for high quality at low bit rate

2:For music sources compressed for standard quality at low bit rate

3:For music sources compressed for low quality at low bit rate

●Setting high pass filter

2-1. Select “HPF”.

3-1. Push the [P.CH] button upward or downward to select the setting. Each time you push the [P.CH] button, the setting changes in the following order:

“THRGH” ↔ “50Hz” ↔ “80Hz” ↔ “120Hz”

∗The factory default setting is “THRGH” (through).

●Setting low pass filter

2-1. Select “S-W LPF”.

3-1. Push the [P.CH] button upward or downward to select the setting.

Each time you push the [P.CH] button, the setting changes in the following order:

“THRGH” ↔ “50Hz” ↔ “80Hz” ↔ “120Hz”

∗The factory default setting is “THRGH” (through).

●Adjusting the balance

2-1. Select “BALANCE”.

3-1. Push the [P.CH] button upward to emphasize the sound from the right speaker, push the button downward to emphasize the sound from the left speaker.

∗The factory default setting is “0”. (Adjustment range: L12 to R12)

●Adjusting the fader

2-1. Select “FADER”.

3-1. Push the [P.CH] button upward to emphasize the sound from the front speaker, push the button downward to emphasize the sound from the rear speaker.

∗The factory default setting is “0”. (Adjustment range: R12 to F12)

English

DXZ675USB 13