Multi-Tech Systems Hub manual Red Red Orange RedRed White

Page 20

Chapter 4 - Hardware removal/ Replacement

4Finish pulling the card cage (including fan enclosure) straight up and out of the chassis. See Figure 4-5. Set it next to the chassis.

Note: Before placing the card cage back into the chassis, verify that the power connectors from the power supply to the backplane are fully attached. Figure 4-5b shows the wire colors and correct orientation of the power cables.

ISI

SBC Board

Fan Enclosure

ISI (3)

Figure 4-5. Card Cage Removal

			Black
			Black
			Blue
			Yellow
	Red O		Red
R Red		range
	ed
B	W
B	hite
	lack
Black

CommPlete

Black

Black

Blue

Yellow

Red

Red Orange

RedRed

White

Black

Black

Figure 4-5b: Wire Colors and Orientation of Power Cables

20	CommPlete 4000 Communications Server User Guide

Image 20

Contents User Guide Record of Revisions PatentsContents Appendices System Overview Product OverviewDocumentation Set Overview RASExpressTechnical Specifications Power SupplyDimensions ChassisSafety Warnings UnpackingRack Mounting Cable ConnectionsSBC Board Cabling SBC BoardISI Board Cabling Shared Interrupt For Top Slots Identical Devices RequiredSerial Card Upgrades Powering Up Power Supply ConnectorsAccessing RASExpress What you need to startA8. Type the IP Subnet Mask CommPlete 4000 Communications Server User Guide B8. Type the IP Subnet Mask Using Dial-In Access Hardware removal/Replacement Disconnecting Cables and Removal from EnclosureCard Cage Removal/Replacement Cover Mounting ScrewsRed Red Orange RedRed White Board Removal and Replacement Removing SBC BoardHard Disk Drive Removal/Replacement Removing ISI BoardsFloppy Disk Drive Removal/Replacement Cdrom Removal/ReplacementPower Supply Removal/Replacement Troubleshooting SBC does not boot correctly or hangs after video appearsNo Video COM1, COM2, or LPT1 port does not respond correctlyKeyboard does not respond to key strokes Diagnostic TestsInvalid Time, Date or Setup Limited Warranty Addendum for North American ProductsOut of Warranty Repair Costs On-line Warranty Registration Technical SupportAddendum for International Products Recording CommPlete 4000 InformationContacting Technical Support Ordering AccessoriesService PinDescription Appendix A-Back Panel Connector PinoutsVGA 15-Pin Connector Pin Description Pin DB9 COM 1 ConnectorPin Circular Jack RJ-45 Connector Pin Floppy Disk Drive ConnectorPinSignal Name Direction Printer Port ConnectorCOM 2 Port Connector Hard Disk Connector IOCS16Appendices Industry Canada FCC Part 15 RegulationCanadian Limitations Notice Compliance with Babt Requirements Example Diagram Showing Creepage Clearance Distances European Low Voltage DirectiveCompliance with BS6789 .1 and Part Compliance with BS6328 PartEMC, Safety, and Terminal Directive Compliance