Multi-Tech Systems Hub Technical Specifications, Chassis, Power Supply, Dimensions, Environmental

Page 7

Chapter 1 - System Overview

Technical Specifications

The CommPlete 4000 conforms to the following technical specifications.

Chassis

6-slot PCI/ISA backplane

SBC

One half-height 1.44Mb 3½-inch floppy disk drive

One half-height IDE hard disk drive

One power supply

Power on/off switch on front panel with built in power LED.

Full security locking

Intelligent Serial Interface card with or without modems/TAs (ISI4608PCI,ISI4608UPCI, ISI5634PCI/8, ISI5634UPCI/8, ISIHP-4S, or ISIHP-4U)

Power Supply

AC Input

Power requirement: 100-120/220-240V; 6A/3A (RMS) selectable by slide switch

Frequency: 50-60 Hz

Efficiency: >65% @ full load, nominal line

DC Output

Output: +5 @ 25A +12 @ 10A -5 @ 0.5A -12 @ 0.5A

Inrush current: <30A peak @ 115VAC, cold start at 25o C

Line regulation: +/- 5% at full load for +/-5V, +/-12V, +/-10% for -12V

Hold Time: 12ms at full load @ 115VAC

Note: 3.3 volts, DC, is available at PCI expansion slots on the backplanes.

Dimensions

Height: 5.25 inches

Width: 19 inches

Depth: 17 inches

Weight: 31 lbs. (14kg)

Environmental

• Temperature:

0–40oC

Humidity: 10–90% RH noncondensing

Fan Rating: 25 cfm

CommPlete 4000 Communications Server User Guide

7

Image 7
Contents User Guide Patents Record of RevisionsContents Appendices Product Overview System OverviewRASExpress Documentation Set OverviewChassis Technical SpecificationsPower Supply DimensionsCable Connections Safety WarningsUnpacking Rack MountingSBC Board SBC Board CablingShared Interrupt For Top Slots Identical Devices Required ISI Board CablingSerial Card Upgrades Power Supply Connectors Powering UpWhat you need to start Accessing RASExpressA8. Type the IP Subnet Mask CommPlete 4000 Communications Server User Guide B8. Type the IP Subnet Mask Using Dial-In Access Disconnecting Cables and Removal from Enclosure Hardware removal/ReplacementCover Mounting Screws Card Cage Removal/ReplacementRed Red Orange RedRed White Removing SBC Board Board Removal and ReplacementRemoving ISI Boards Hard Disk Drive Removal/ReplacementCdrom Removal/Replacement Floppy Disk Drive Removal/ReplacementPower Supply Removal/Replacement COM1, COM2, or LPT1 port does not respond correctly TroubleshootingSBC does not boot correctly or hangs after video appears No VideoInvalid Time, Date or Setup Diagnostic TestsKeyboard does not respond to key strokes Addendum for North American Products Limited WarrantyRecording CommPlete 4000 Information Out of Warranty Repair Costs On-line Warranty RegistrationTechnical Support Addendum for International ProductsService Ordering AccessoriesContacting Technical Support VGA 15-Pin Connector Appendix A-Back Panel Connector PinoutsPinDescription Pin Circular Jack Pin DB9 COM 1 ConnectorPin Description Pin Floppy Disk Drive Connector RJ-45 ConnectorCOM 2 Port Connector Printer Port ConnectorPinSignal Name Direction IOCS16 Hard Disk ConnectorAppendices Canadian Limitations Notice FCC Part 15 RegulationIndustry Canada Compliance with Babt Requirements European Low Voltage Directive Example Diagram Showing Creepage Clearance DistancesCompliance with BS6328 Part Compliance with BS6789 .1 and PartEMC, Safety, and Terminal Directive Compliance