Multi-Tech Systems MT5600BAV.92, MT5600BLV.90, MT5600BAV.90 manual Leased Line Operation

Page 32

Chapter 4 - Leased Line Operation

8.To change the default restore time, press to go to the TIME TO RESTORE (S15) screen, then press ◊, ◊. The ENTER TIME IN MINUTES screen ap- pears.

9.Press the 〈⇓ or button several times to select the first digit in the number.

10.Press the ◊ button to go to the next digit in the number.

11.Repeat steps 9 and 10 until you have entered a value between 10 and 255, or 0 to disable dial backup, and then press the Enter button to store it. The TIME STORED screen appears.

12.Press the Enter button to return to the TIME TO RESTORE (S15) screen.

13.To change the default dial backup time, press to go to the DIAL BACKUP TIME (S17) screen, then press ◊, ◊. The ENTER TIME IN MINUTES screen appears.

14.Repeat steps 9 and 10 until you have entered a value between 0 and 255, and then press the Enter button to store it. The TIME STORED screen appears.

15.Press the Enter button again to return to the DIAL BACKUP TIME (S17) screen. 16 . Dial backup and leased line restoral setup is complete.

Note: Registers S15 and S17 can also be changed using the Sr=n AT command. See the AT Command Reference Guide on the CD that was shipped with your modem.

Note: The dial backup number can be displayed only 16 characters at a time. To see characters 17–30, press the button. To go to the previous screen, press the ⇓ button. To go to the next screen, press the ◊ button.

Multi-Tech Systems, Inc. MT5600BA/BL Series User Guide

32

Page 31 Page 33
Image 32
Page 31 Page 33
Contents MT5600BA/BL Series Revision Date Description Table of Contents Contents General Description and Features Telephone systems Installation Wall jack$#%#8. Click Finish to exit +,-./0$1Chapter 2 Installation 345 Using the Front Panel Using the Front Panel Front panelTrunks LimbsTwigs Limbs Branches Twigs From previous Limbs Branches Twigs Using the Front Panel Limb Branches Twigs Using the Front Panel Using the Front Panel Multi-Tech Systems, Inc. MT5600BA/BL Series User Guide Using the Front Panel Using the Front Panel Using the Front Panel Ters, press the 〈 and  buttons. To go to the next position Using the Front Panel Leased Line Operation Leased Line Operation Leased Line Operation Leased Line Operation Remote Configuration Modem you must use the new password Remote ConfigurationCallback Security Available Callback SecurityIng strings have been entered Callback Security Callback Enable/Disable # Callback Security Troubleshooting Troubleshooting Troubleshooting Assistance see Appendix DTroubleshooting Troubleshooting Troubleshooting Appendix a Regulatory Compliance Appendix a Regulatory Compliance Modem to become non-compliant Exceed Commands Command BufferError Correction Mode of OperationAppendix B Technical Specifications ConnectorsDiagnostics IndicatorsAppendix C Warranty,Service, and Technical Support Sep-01 Appendix C Warranty, Service, and Technical Support DEFAULT.ASPEtc Restore your parameters Not 6.xx firmware Close the terminal program Com4 ttyS3 Using the Modem to Call the Internet Appendix E Installing a Modem Under LinuxAppendix F Pin Descriptions Appendix F Pin Descriptions RDLFig. F-4. Two-wire leased line cable Index IndexSerial cable Windows
Top Page Image Contents