Multi-Tech Systems MT2834BL Series, MT2834BA Series manual MultiModemBA Connections

Chapter 2 - Installation and Connection

2.Verify that the ON/OFF switch at the rear of the modem to the OFF (Down) position.

3.For BA: Connect the modem to a dial-up line by attaching the RJ-11 telephone cord (provided with your unit) to the LINE connector on the modem and to a dial-up wall jack.

PHONE LINE EIA RS232C ON

VOLUME OFF

POWER

Figure 2-1. MultiModemBA Connections

The LINE connector can be used for a dial-up connection or a 2-wire leased-line connection.

3.For BL: Connect the modem to either a dial-up line or lease-line.

To connect the modem to a dial-up phone line, attach the RJ-11 telephone cord (provided with your unit) to the PSTN connector on the modem and to a dial-up wall jack.

To connect the modem to a leased line, attach the RJ-11 telephone cord (provided with your unit) to the LEASE connector on the modem and to a leased line wall-jack.

PHONE PSTN LEASE	EIA RS232C	ON
VOLUME		OFF
		POWER

Figure 2-2.BL Connections

The PSTN connector is used for a dial-up connection.

The LEASE connector can be used for a 2-wire or 4-wire leased-line connection.

4.Attach the EIA RS-232Cconnector on the modem to the serial port on your computer or terminal with an RS-232 (or V.24) cable (you supply).

5.To connect a telephone set to the modem (optional) plug one end of an RJ-11 phone cord into the PHONE connector on the modem, and plug the other end into your telephone.

6.Attach the AC Power transformer provided with your unit to the POWER connector on the modem and to a live AC outlet.

Note: Only apply power to the modem using the power transformer provided with your unit. Use of a power supply not designed for your unit could result in damage to your modem and will void the warranty.

7.Apply power to the unit by setting the position.

ON/OFF switch at the rear of the modem to the ON (Up)

Multi-Tech Systems, Inc. MT2834BA/BL Series User Guide 15