Multi-Tech Systems MT5634ZPX-PCI-V92 Nn Error Correction Mode Selection, Tn Inactivity Timer

MultiModemZPX User Guide		4 AT Commands, S-Registers, and Result Codes
Command:	\Nn	Error Correction Mode Selection
Values:		n = 0–5, or 7
Default:		3
Description:	\N0	Non-error correction mode with data buffering (buffer mode;
		same as &Q6).
	\N1	Direct mode.
	\N2	MNP reliable mode. If the modem cannot make an MNP
		connection, it disconnects.
	\N3	V.42/MNP auto-reliable mode. The modem attempts first to
		connect in V.42 error correction mode, then in MNP mode, and
		finally in non-error-correction (buffer) mode with continued
		operation.
	\N4	V.42 reliable mode.If the modem cannot make a V.42
		connection, it disconnects.
	\N5	V.42, MNP, or non-error correction (same as \N3).
	\N7	V.42, MNP, or non-error correction (same as \N3).
Command:	\Qn	Flow Control Selection
Values:		n = 0, 1, or 3
Default:		3
Description:	\Q0	Disables flow control (same as &K0).
	\Q1	XON/XOFF software flow control (same as &K4).
	\Q3	RTS/CTS hardware flow control (same as &K3).
Command:	\Tn	Inactivity Timer
Values:		n = 0, 1–255
Default:		0
Description:	\Tn	Sets the time (in minutes) that the modem waits after the last
		character is sent or received before it disconnects. A value of
		zero disables the timer. Applies only in buffer mode.

Note: You can also set the inactivity timer by changing the value of S30.

Command:	\Vn	Protocol Result Code
Values:		n = 0, 1, or 2
Default:		1
Description:	\V0	Disables the appending of the protocol result code to the DCE
		speed.
	\V1	Enables the appending of the protocol result code to the DCE
		speed.
	\V2	Same as \V1.
Command:	\Xn	XON/XOFF Pass-Through
Values:		n = 0 or 1
Defaults:		0
Description:	\X0	Modem responds to and discards XON/XOFF characters.

30