Blaupunkt CM 168 operating instructions Radio operation

Page 11

Radio operation

Selecting a waveband

With this car radio you can select between the following wavebands:

FM 87.5 – 108.0 MHz

AM 531 – 1602 kHz

Select the desired waveband by pressing the BA/TS button.

Station tuning

Automatic seek tuning /

Press or ; the car radio will auto- matically search for the next station.

If you hold / pressed up or down on the rocker switch, seek tuning will speed up in the upwards or downwards direction.

Automatic seek tuning

Up

Down

Manual tuning with << >>

You can also tune into a station manually.

Press << >>; the frequency will

change in short intervals in the down- wards or upwards direction.

If you hold << >> pressed to the left or the right on the rocker switch, the frequency scan will speed up.

Switching between the memory banks (FM)

You can switch between the memory banks FM1, FM2 and FMT in order to store sta- tions and recall them later.

The currently selected memory bank ap- pears in the display.

Press the BA/TS button as many times as necessary until the desired memory bank lights up in the display.

Storing stations

On FM, you can store six stations on the preset buttons 1, 2, 3, 4, 5, 6 for each of the memory banks (FM1, FM2, FMT).

You can also store six stations on AM.

Select the waveband by pressing BA/TS.

Tune into a station with the rocker switch (either automatically / or manually << >>).

Press the desired preset button until the radio resumes play after the mut-

ing (takes approximately 2 seconds) or until you hear a beep.

Now the station has been stored.

The display will temporarily indicate which preset button is currently activated.

Recalling stored stations

You can recall any stored station at the touch of a button.

Select the waveband by pressing BA/TS. For FM, also choose the cor- responding memory bank by pressing the BA/TS button as many times as necessary until the desired bank ap- pears in the display.

Press the corresponding preset button briefly to recall the station.

Scanning stations with

Preset Scan

You can scan all of the radio stations on AM or FM.

The scanned stations of the current wave- band will appear briefly one after the other in the display.

Start Preset Scan:

Press PS briefly.

“PS-Scan” and the station name or frequen- cy will appear alternately in the display.

ENGLISH

11

Image 11
Contents Munich CM Page Display field DisplayContents Quick reference Repeat track press once briefly Additional rocker switch functionsSelect CD Select trackPause Preset buttons 1 toMTL DolbySCA Scan Remote control operation@ Preset Scan Important notes Traffic safetyInstallation AccessoriesAffixing the detachable face Detachable faceTheft protection Radio operation Naming radio stations Selecting the automatic tuning sensitivityScanning stations with Radio Scan Changing the scan timeDeleting all of the radio station names Setting the TimerDeleting radio station names Deleting a radio station nameCassette deck operation CD changer operation CD Select-By-Name Selecting a trackDeleting one CD name Naming CDsDeleting CD names Deleting all CD names Setting the clockClock/Display changes Turn On Message TOM Naming an external audio sourceDSC programming RM on Overview of the DSC factory settingsCassette SpecificationsAmplifier TunerCD Changer operation Troubleshooting GuideGeneral Radio receptionCD ERR Error DisplaysK7/VKD 8 622 401