Blaupunkt CM 168 Troubleshooting Guide, General, Radio reception, CD Changer operation

Page 23

Troubleshooting Guide

The following check will assist in the correction of most problems which you may encounter with your unit. Before going through the check list below, refer back to the connection and operating procedures.

ENGLISH

General

Trouble

Cause/Solution

 

No sound.

Adjust the volume with the volume knob.

 

With a two-speaker system, set the fader control to the center position.

Radio reception

 

 

 

Trouble

Cause/Solution

 

Preset stations are not receivable.

The broadcast is too weak.

 

Automatic tuning is not possible.

The broadcast is too weak

Use manual tuning.

Travelstore feature does not complete

Not enough broadcast frequencies are receivable.

storing of six stations.

 

 

 

Also make sure that antenna is connected, extended and dry inside.

CD Changer operation

Trouble

Cause/Solution

CD does not start.

Dusty or defective disc.

 

The ambient temperature is more then 50° C (120° F).

The disk cannot be loaded or is automatically ejected.

The sound skips due to vibration.

The disc is inserted with the printed side downwards.

The changer is installed at an angle of more than 20°.

The changer is not installed on the sturdy part of a car.

Dusty or defective disc.

23

Image 23
Contents Munich CM Page Display field DisplayContents Quick reference Repeat track press once briefly Additional rocker switch functionsSelect CD Select trackPause Preset buttons 1 toMTL DolbySCA Scan Remote control operation@ Preset Scan Important notes Traffic safetyInstallation AccessoriesAffixing the detachable face Detachable faceTheft protection Radio operation Naming radio stations Selecting the automatic tuning sensitivityScanning stations with Radio Scan Changing the scan timeDeleting all of the radio station names Setting the TimerDeleting radio station names Deleting a radio station nameCassette deck operation CD changer operation CD Select-By-Name Selecting a trackDeleting one CD name Naming CDsDeleting CD names Deleting all CD names Setting the clockClock/Display changes Turn On Message TOM Naming an external audio sourceDSC programming RM on Overview of the DSC factory settingsCassette SpecificationsAmplifier TunerCD Changer operation Troubleshooting GuideGeneral Radio receptionCD ERR Error DisplaysK7/VKD 8 622 401