IP CONTROL
About - Click About to verify the Client, Firmware, KME (Keyboard/Mouse Emulation firmware) and Switch file versions installed on your IP Control.
Local Settings – Click Local settings, the Client Configuration box appears, see Figure 23
Figure 23 Client Configuration box
Pointer type – From the
Hide Toolbar – Check this option to hide the Toolbar from the next reconnection onwards. To toggle the Toolbar on and off, press F9. See above page 19.
Full Screen Mode - Check this option to make the remote session screen appear in full screen mode from the next reconnection onwards. To toggle the full screen mode on and off, press F11.
23.11 Disconnecting the remote session
To disconnect the session, on the Toolbar, click . The Login box appears. You can
24. Troubleshooting - Restoring factory defaults
Section 21 on page 17 explained how to restore factory settings from the Web interface. When you cannot access the system e.g. you have forgotten the Username or Password, you can restore factory defaults from the IP Control unit.
To restore factory defaults:
1.Press and hold down the
2.Wait until the unit finishes booting.
3.Type into the Address box: http://IP address/config. (Do not start the address with https). The Login box appears see Figure 24.
27