Milan Technology MIL-W1311 manual Dial-in Configuration, Creating a Dial-in Connection in Windows

PC Configuration

Dial-in Configuration

This section describes how to configure your PC to use the Wireless Gateway's RAS Dial-in feature.

To use the RAS Dial-in feature of the Wireless Gateway:

•An Analog Modem or ISDN TA must be connected to the Serial Port on the Wireless Gateway.

•The Wireless Gateway's Serial Port screen must be configured for Dial-in access, and Dial-in Users must be created. See Chapter 6 - Serial Port for details.

•A suitable Dial-up connection must be created on your PC, as described below.

Creating a Dial-in Connection in Windows

You can use the standard Windows Dial-up Networking software normally used for Internet access. The procedure is as follows:

1.Ensure your modem is installed and working.

2.Select My Computer, then Dial-up Networking.

3.Click Make new Connection, and step through the Wizard.

•Give this connection a suitable name.

•Enter the area code and telephone number to connect to the Wireless Gateway.

•Continue the Wizard until completed.

4.The default values for this connection will work with the Wireless Gateway's default values. If necessary, you can adjust the Properties for the connection:

•In the Dial-up Networking window, select the connection.

•Right-click, and select Properties to see a screen like the one below.

Figure 18: Dial-up Networking Properties

35