Minicom Advanced Systems 108 IP, 108/116 IP manual Snmp Events Table, Event Text Code Comment

SNMP Events Table

9 SNMP Events Table

The following table lists all recorded events.

Event Text	Code	Comment
System Boot	1010	Reported upon device boot-up.
Server Busy ask	1030	Attempt to connect when another user is already connected. The second
for disconnect.		user has permission for takeover; sent before the second user actually
		takes over the session.
User login	1040	On every successful user login to the device.
succeeded
Login failed wrong	1050	Login failed due to wrong user name or password.
user name or
password
Login not	1060	Login denied because a user with higher permission is connected
succeeded server		(takeover not allowed).
busy
Logout	1070	User Logout (end of remote access session).
Disconnected by	1110	Takeover has been successfully performed; the previous user has been
another user		disconnected.
Hardware Failure	1200	Device internal hardware failure. Try disconnecting any other attached
		device and reboot. If problem persists, contact technical support.
Hard reset power	1220	Power cycle command issued; only relevant when a special power-cycle
cycle command		product is attached to the device (for exmple, KBPower).
Viewer login	1230	User connected in view-only mode (while another user is connected in a
		regular session).
Viewer logout	1240	User connected in view-only mode has disconnected.
Global access	1250	Device has been blocked for access by an administrator; remote access
disabled		is disabled until the device is unblocked.
Block User	1260	User blocked due to too many login attempts; failure per policy in
Account		configuration.
Successful User	2010	Successful User Login. CONF_USER_EVENT_LOGIN_SUCCEEDED
Login
Login is not	2020	Login is not successful – wrong user access level.
successful –		CONF_USER_EVENT_LOGIN_NOT_SUCCEEDED_WRONG_LEVEL
wrong user access
level.

84 Smart 108/116 IP