www.mgeups.com
Network
Management Cards
User Manual
This page is used to define either the shutdown or the notification settings used by the Network Shutdown Modules that connect to Network Management Card. These settings are used by the Network Shutdown Modules if they are in
ZShutdown After (time before shutdown) This is the time in seconds that the system waits following failure of AC power before initiating the
If another criterion occurs before the end of the shutdown timer, the shutdown procedure is immediately run.
This parameter is optional, uncheck it to invalidate
ZShutdown Duration : This is the time in seconds required by the system to go through its shutdown procedure.
ZBroadcast : Send network notifications to the Administrators and Users groups on events
If you wish to set up a new configuration for the Network Shutdown Modules already set to centralized- configuration mode, proceed as indicated below.
ZChange the Network Shutdown Module parameters in the page “Central Shutdown Configuration”.
ZClick the Save button. Open the List of notified applications.
Select the Network Shutdown Modules to receive the new configuration.
Press the button “Remove” They reconnect and use the new configuration
3.5.5 Access control
Click the “Access control” section in the menu.
To access this page, the login and password are systematically requested if they have not already been entered.
This menu enables configuration of the different parameters enabling secure access to the card via a browser or SNMP.
T H E U N I N T E R R U P T I B L E P O W E R P R O V I D E R
Network Management Card – User Manual | 34003676EN/GA | Page 37/69 |