LSI 25083 manual Card Layout for the MegaRAID SAS 9240-8i RAID Controller

Note: The SAS 9240-4i RAID controller does not contain the J5 connector, which supports ports 4–7. The SAS 9240-8i RAID controller contains the J5 connector.

This subsection provides the board layout and connector and jumper information for the RAID controller. Figure 3.2 shows the jumpers and connectors on the SAS 9240-8i RAID controller.

Figure 3.1 Card Layout for the MegaRAID SAS 9240-8i RAID

Controller

J2

J3

J4 J5

J6 85043-00

Table 3.2 describes the jumpers and connectors on the SAS 9240-4i and 9240-8i RAID controllers.

3-2	MegaRAID SAS RAID Controller Characteristics
	Copyright © 2009 by LSI Corporation. All rights reserved.