
IBM BladeCenter Deployment Guide
Figure 8 Storage Connection Diagram
2.4.2 Disabling ports on the QLogic switch
Here are the steps necessary to disable ports on the QLogic switch. This can be done either via a telnet session or a browser session.
2.4.2.1 Using Telnet
1.Start a telnet session with the IP address of the QLogic Switch Module.
2.After logging in, enter the command ”show port” to view the current status of the ports.
| Admin | Operational | Login | Config | Running | Link | Link |
Port | State | State | Status | Type | Type | State | Speed |
Ext1:0 | Online | Online | LoggedIn | GL | F | Active | 1Gb/s |
Ext2:15 | Online | Offline | NotLoggedIn | GL | Unknown | Inactive | Auto |
Bay1 | Online | Online | LoggedIn | F | F | Active | 2Gb/s |
Bay2 | Online | Offline | NotLoggedIn | F | Unknown | Inactive | 2Gb/s |
Bay3 | Online | Offline | NotLoggedIn | F | Unknown | Inactive | 2Gb/s |
Bay4 | Online | Online | LoggedIn | F | F | Active | 2Gb/s |
Bay5 | Online | Offline | NotLoggedIn | F | Unknown | Inactive | 2Gb/s |
Bay6 | Online | Offline | NotLoggedIn | F | Unknown | Inactive | 2Gb/s |
Bay7 | Online | Offline | NotLoggedIn | F | Unknown | Inactive | 2Gb/s |
Bay8 | Online | Offline | NotLoggedIn | F | Unknown | Inactive | 2Gb/s |
Bay9 | Online | Offline | NotLoggedIn | F | Unknown | Inactive | 2Gb/s |
Bay10 | Online | Offline | NotLoggedIn | F | Unknown | Inactive | 2Gb/s |
Bay11 | Online | Offline | NotLoggedIn | F | Unknown | Inactive | 2Gb/s |
Bay12 | Online | Offline | NotLoggedIn | F | Unknown | Inactive | 2Gb/s |
Bay13 | Online | Offline | NotLoggedIn | F | Unknown | Inactive | 2Gb/s |
Bay14 | Online | Offline | NotLoggedIn | F | Unknown | Inactive | 2Gb/s |
|
|
|
|
|
|
|
|
Figure 9 Port Status Online
Version 3.0, 3/10/2006 | 13 |
The BladeCenter Deployment Guide is intended as a personal productivity tool. It is not intended to be comprehensive and is provided for
guidance only, on an 'as is basis' without warranty of any kind. Please be aware that its contents have not been certified by IBM.