AKG Acoustics CS 5

Section 2: Notes on Wiring and System Examples

2.2.4 Large Conference System with Interpretation Booths

Example 4: Large conference system layout and wiring diagram.

Example 4 shows a large conference system with CS 5 VU microphone stations with voting and polling functions, an

interpretation booth for one target language, and an infrared distribution system for the audience. The chairperson, pan-

elists, and delegates can listen to the loudspeakers on the Delegate Stations or use the headphones to listen to the in-

terpreters. Since all microphones are connected to CS 5 microphone stations, no external microphone mixer is needed.

The audience can listen to the floor signal or interpretation on their CS 5 IRR 7 infrared receivers with channel selec-

CS 5 User Manual - 11 -

Layout

Wiring Diagram

Contents

Main Page Table of Contents Symbols Used Safety and Environment Safety Instructions Environment FCC Statement Section 1: General 2.1 Notes on Wiring and System Configuration Page 2.2.2 Computer-controlled Discussion System Page Page Page 3.1 General 3.2 Front Panel 3.3 Rear Panel Page 3.4.2 Configuring the Dip Switches 3.4.3 Selecting NOM Limitation/Interpretation Channels 3.4.4 Powering Up 3.4.5 Setting Levels 3.4.6 Selecting NOM Limitation/Interpretation Channels Section 4: CS 5 DU Delegate Station 4.1 Introduction 4.2 Controls, Inputs, and Outputs Section 4: CS 5 DU Delegate Station 4.3 Setting Up 4.3.1 Making Connections 4.3.2 Selecting Operating Modes Page 5.1 Introduction 5.2 Control Panel, Inputs, and Outputs Page 5.3 Setting Up 5.3.1 Making Connections 5.3.2 Selecting Operating Modes 5.3.3 DELEGATE Mode 5.3.4 PRESIDENT Mode 5.4 Voting/Polling 5.4.1 Controlling a Ballot or Opinion Poll (PRESIDENT Mode) 5.4.2 Voting in DELEGATE Mode 5.5 Chip Card Identification 6.1 Introduction 6.2 Control Panel, Inputs, and Outputs 6.3 Setting Up 6.3.1 Making Connections 6.3.2 Selecting Station Addresses 6.3.3 Selecting Target Language Channels 6.3.4 List of Available Language Names 6.3.5 Selecting the Microphone Type 6.4 Using the Interpreter Station Page 7.1 CS 5 IRT 1 and CS 5 IRT 2 Infrared Radiators 7.1.1 General 7.1.2 Placement 7.1.3 Mounting 7.1.4 Connections 7.2 CS 5 IRR 7 Infrared Receiver 7.2.1 General 7.2.2 Using the Infrared Receiver 7.2.3 Replacing Batteries 7.3 CS 5 CU 50 Charger/Storage Case 7.3.1 General 7.3.2 Charging Batteries 7.3.3 Battery Care Section 8: System Components 9.1 CS 5 BU 9.1.1 General 9.1.2 Connector Pinouts Page 9.2 CS 5 DU/VU 9.2.1 General 9.2.2 Connector Pinouts CS 5 IU 9.3.1 General 9.3.2 Connector Pinouts 9.4 CS 5 PS 12 9.5 CS 5 IRT 1 and CS 5 IRT 2 9.6 CS 5 IRR 7 9.7 CS 5 CU 50 9.8 Conformity