AKG Acoustics user manual CS 5 DU Delegate Station, Setting Up, Making Connections

Section 4: CS 5 DU Delegate Station

Refer to	5	Talk button: Pressing the talk button once activates the microphone. The status LED above the button will be lit.
fig. 4		Pressing the talk button again switches the microphone off. The status LED above the button will go out.
on page 18.		If no microphone channel is available, the microphone will not be activated before a channel becomes available.
		The status LED will be flashing. Pressing the talk button again cancels the floor request and the status LED will go
		out. The talk button also allows simple two-way (aye/no) voting (refer to section 5.4.2).
	6	Loudspeakers.
	7	DC input for connecting a CS5 PS 12 power supply.

8System port: RJ45 connector for CS5 MK.. LAN cables. (Refer to section 2.2 for example wiring diagrams.)

4.3Setting Up

4.3.1Making Connections

1.Screw the microphone capsule on the gooseneck.

2.Screw the gooseneck into the microphone input (2).

Fig. 4, p. 18. 3. Use the appropriate CS5 MK.. cables to connect the system ports on the microphone station to the system ports on the preceding and subsequent microphone stations.

4.3.2 Selecting Operating Modes

Important:

!• To avoid malfunctioning, do not change any dip switch settings on the Base Unit or any microphone sta- tion while power to the system is ON!

Table 2: CS 5 DU dip switches.

Dip switches	Function			Switch positions
S1, S2	Match microphone station audio input
			Dip switch		Microphone model
	to microphone output signal.
		S1		S2
		0		0	CK 31 cardioid microphone
		0		1	CK 33 hypercardioid microphone
		1		1	CK 47, CK 80 shotgun microphones
S3	Unused
			0			1
S4	Microphone muting on priority request:	Microphone can be muted.				Microphone will not be muted.
S5, S6	Switch left-hand phones output to channel
				Channel			S5	S6
	(language selection):
				Floor			0	0
			CH 1 or EXT. LANG.				1	0
				CH 2			0	1
				CH 3			1	1
S7, S8	Switch right-hand phones output to channel
				Channel			S7	S8
	(language selection):
				Floor			0	0
			CH 1 or EXT. LANG.				1	0
				CH 2			0	1
				CH 3			1	1

1.Referring to Table 2 above, set S1 and S2 for the microphone capsule you are going to connect to the microphone station.

The settings of S1-S2 determine the frequency response and gain of the audio section as well as the amount of gain reduction that is applied to the loudspeaker amplifier as soon as the microphone opens. Therefore, microphone stations with unidirectional microphone capsules allow delegates to hear other talkers on the built-in loudspeak- ers even while the microphone is open.

CS 5 User Manual - 20 -