IBM BladeCenter Deployment Guide
[root@localhost root]# mount /dev/sda /mnt/floppy [root@localhost root]# ls
total 285
[root@localhost root]#
[root@localhost root]# cd /tmp
[root@localhost tmp]# rpm
[root@localhost tmp]# cd /usr/src/redhat/ [root@localhost redhat]#
[root@localhost redhat]# rpmbuild
...
Executing(%build): /bin/sh
gcc
gcc
ld
...
Processing files:
Executing(%doc): /bin/sh
Finding Provides:
Finding Requires:
PreReq: /bin/sh /bin/sh /bin/sh rpmlib(PayloadFilesHavePrefix) <=
Requires(interp): /bin/sh /bin/sh /bin/sh
Requires(rpmlib): rpmlib(PayloadFilesHavePrefix) <=
Requires(post): /bin/sh
Requires(preun): /bin/sh
Requires(postun): /bin/sh
Requires:
Executing(%clean): /bin/sh
[root@localhost redhat]# rpm
Figure 35 RPM Install of Broadcom Device Drivers
4.5 Issues related to Red Hat AS 2.1/3.0 and blades
1.The firmware for HS40 blades MUST be updated to the minimum levels shown in Table 5 HS40 BIOS and ISMP Information if the blade is going to be running Linux. There is a problem identified in the 1.32 version of the BIOS, related to EFI, which causes processors to be disabled. The only fix for this error is to upgrade the BIOS and ISMP firmware.
2.Installing Red Hat by booting from remote CDs is not currently supported on the HS40. Installing the
30 | © 2006 IBM Version 3.0, 3/10/2006 |
The BladeCenter Deployment Guide is intended as a personal productivity tool. It is not intended to be comprehensive and is provided for
guidance only, on an 'as is basis' without warranty of any kind. Please be aware that its contents have not been certified by IBM.