Lucent Technologies P333T manual Fdx

				Chapter 2	Cajun P333T Front and Rear Panels
Table 2.1	Cajun P333T LED Descriptions
LED Name		Description		LED Status
FDX		Half/Full Duplex		OFF – Half duplex mode
				ON – Full duplex mode
				OFF – No flow control. Symmetric Pause
		Symmetric Flow		mode is disabled and/or port is in half duplex
FC				mode
		Control
				ON – Symmetric Flow Control mode is
				enabled and port is in full duplex mode
Hspd		High Speed		OFF – 10Base-T port or expansion port does
				not exist
				ON – 100Base-T, 100Base-F, and 1000Base-
				X port
LAG		Link Aggregation		OFF – No LAG defined for this port
		Group (Trunking)		ON – Port belongs to a LAG
Table 2.2	Cajun P330 <- -> Select buttons
Description			Function
Left/Right			Individual – select LED function (see table above)
Reset module			Press both right and left buttons together for approximately two
			seconds. All LEDs on module light up until buttons are released
Reset stack			Press both Right and Left buttons together for 4 seconds. All
			LEDs on stack light up until buttons are released.
FIV			Force Initial Version – boot from backup initial version of the
			Cajun P330 software, from Bank A (see Note below).

Note: To perform “Force Initial Version” reset the module and at the same tme press the FIV reset button (use an opened paper clip or other pointed object). Let go of the reset buttons first and then let go of the FIV button 1 or 2 seconds later.

Cajun P333T User’s Guide 9