Chapter 5 Cajun Campus CLI (Command Line Interface)
Set system contact command
Use the Set system contact command to set mib2 system contact MIB variable
The syntax for this command is:
set system contact [string]
string | location string. The location is cleared if this field is blank. |
Set interface command
Use the set interface command to configure the
The syntax for this command is:
set interface [name][vlan][ip_addr][netmask]
name | interface name (“inband” used for Master agent) |
vlan | the number of the VLAN to be assigned to the interface |
ip_addr | IP address |
netmask | Subnet mask |
Set port level command
Use the set port level command to set the priority level of a port or range of ports on the switching bus. Packets traveling through a port set at normal priority should be served only after packets traveling through a port set at high priority are served.
The syntax for this command is:
set port level [mod_num/port_num][normalhigh]
mod_num | Number of the module. |
port_num | Number of the port on the module. |
normal | Set the port priority to regular. |
high | Set the port priority to high. |
Example
To set the priority level for port 2 on module 1 to high:
Console> (enable) set port level 1/2 high
Port 1/2 port level set to high.
Console> (enable)
Cajun P333T User’s Guide | 49 |