Lucent Technologies P220, P550R manual Snmp, Spanning Tree

Page 18

SNMP

NOTES:

Cold start traps cannot be transmitted out of inband interfaces when Spanning Tree is enabled.

ipAddrTable does not display inactive interfaces (VLANs). An inactive interface occurs when there are no active ports on a VLAN.

You cannot have more than 10 SNMP community strings per switch.

Spanning Tree

NOTES:

The Cajun P550 48-port Media Module (M5548E-100TC) supports Spanning Tree for each group of eight ports at the internal switch port. Spanning Tree functionality is disabled by default. If per-port STP is required, it is recommended that you use a Cajun P550 20-port Module (M5520-100TX) or Cajun P550 Layer 3 12-port Copper Module (M5512R-100TX).

Release 4.0.1 does not allow modification of the Spanning Tree and Fast Start features on the CPU switch port. When you modify all switch ports, the Spanning Tree and Fast Start features will be not be applied for the CPU switch port and the corresponding status line does not display.

Spanning tree convergence may take longer than 30 seconds in complex networks after a topology change

Problem: When IEEE 802.1D spanning tree is used with hunt groups, the non-flood ports are shown as forwarding, even if the hunt group is blocked.

Workaround: The flood port of the hunt group shows the actual state of the spanning tree. View the flood port to see the actual state of the spanning tree.

Cajun P220, P550, P550R Switch Release Notes, Release 4.0.1

18

Image 18
Contents Software Release November Page Read Me First Overview New Features Additional Undocumented Features BOOTP/DHCP Relay GatewaySource Interface Determination BOOTP/DHCP Relay Gateway VlanProduct Binaries Product Binary FilesInstallation Downgrading to a Previous ReleaseModule Descriptions Upgrading from Release 3.1 or Previous Releases Cajun P220, P550, P550R Switch Release Notes, Release Problems and Workarounds Cajun 48-Port 10/100 Media ModuleWorkarounds Command Line Interface Cajun DocServerHardware Frames Transmitted with CRC ErrorsFront Panel Display Hot Swap ModulesM5520-TX Loopback Tests During Cold Start Short Cables May Cause Auto-negotiation ProblemsLoopback Tests M5520-TX Auto-negotiation with Xircom Adapter CardsIntelligent Multicasting ExampleOspf Piggyback PortsSnmp Spanning TreeTime Zones PPP and TelnetVlan Issues Configuring VLANsDuplicate Vlan Error Message Ieee 802.1Q Packets Gigabit Ports Do Not Perform Auto-negotiation Functional RestrictionsPing Hot Swapping ModulesRedundant Controller Support Web ConfigurationSetting the Spanning Tree Mode Auto-NegotiationTftp Download Status Delay File Naming Standard for Embedded Nvram File SystemBug Fixes Additional Undocumented Commands Buffering CommandsBuffering Commands Mod-swport-spec Mod-swport-spec switch port Fabric-port-spec fabric port specifierMod-swport-spec Dvmrp Commands Dvmrp CommandsThreshold 0,127,255 Igmp Commands Igmp CommandsIP Commands IP CommandsAddrif NamestaticIPX Commands IPX CommandsDisabled Ipx max-service-entriesMax-service-entries BothinboundoutboundLdap Commands Ldap CommandsNo logging console Logging Commands10 Logging Commands No logging historyNo logging shutdown Ospf Commands11 Ospf Commands No logging trapsPolicy Commands 12 Policy Commands65535 Mod-swport-spec specifies Port Commands13 Port Commands Sample-interval14 Snmp Commands Snmp CommandsSwitch IP Commands 15 Switch IP CommandsSystem Commands 16 System CommandsUrlip ip-addr UI Commands 17 UI CommandsIpx-network.next-hop