Lucent Technologies P550R, P220 Ipx max-service-entries, Max-service-entries, Bothinboundoutbound

Table 1-8: IPX Commands (Continued)

Old Command	New Command	New Definition/Argument
N/A	To Enable:	Specify the maximum number of IPX
	ipx max-service-entries	services in the service table. Use the
	<max-service-entries>	no release of the command to return
		to the default value of 2048.
	To Disable:	If the maximum number of services is
	[no] ipx max-service-	decreased, the switch must be reboo-
		ted for the value to take effect. If the
	entries
		value is increased, the change occurs
		immediately.
		<max-service-entries> – the
		maximum number of IPX services that
		can appear in the service table. The
		value must be in the range 1 to 10240.
		The value you enter is rounded up to
		the nearest multiple of 256.
		Command Mode: Configuration
		System Supported: P550R
N/A	To Enable:	Set the type of IPX ping packet issued
	ipx ping-default	by the router when the ipx ping
	{novelldiagnostic}	command is issued. Use the no form
		of the command to return to the
	To Disable:	default ping type; novell.
		•	novell – transmits standard
	[no] ipx ping-default
			Novell pings.
		•	diagnostic – transmits diagnostic
			request/response pings.
		Command Mode: Configuration
		System Supported: P550R
To Enable:	To Enable:	•	both – The interface accepts and
ipx type-20-	N/A		forwards type 20 propagation
propagation			broadcast packets. This is the
{bothinboundoutbound	To Disable:		default.
disabled}	[no] ipx type-20-	•	inbound – The interface only
	propagation		accepts type 20 broadcast packets.
To Disable:	{bothinboundoutbound	•	outbound – The interface only
[no] ipx type-20-	disabled}		forwards type 20 propagation
propagation			broadcast packets to other
			network segments.
		•	disabled – The interface does not
			accept or forward type 20
			propagation broadcast packets.

Cajun P220, P550, P550R Switch Release Notes, Release 4.0.1 31