If a port is inadvertently configured to use 3Com tagging, use the following procedure:
1.Reconfigure the port to use either Clear or IEEE 802.1Q tagging.
2.Copy (Save) the Running-Config to the Startup-Config.
3.Reboot the switch.
NOTES:
•3Com VLT Tagging is not supported but can be enabled on the Cajun P550 48-port Media Module’s (M5548E-100TC) internal switch ports by using the Web or CLI management interface.
•The Cajun P550 48-port Media Module (M5548E-100TC) has been optimized for desktop connections. Spanning Tree topology change convergence time can be lengthy. This could lead to loss of connectivity and/or wrongful flow of data.
Command Line Interface
The command "set vlan <vlan-id> <port>" is used to bind additional ports to a VLAN if trunking is enabled on that port. To set the port default VLAN for a port, use "set port vlan
{<mod-num><mod-port-range>}[...[,]{<mod-num><mod-port-range>}] <vlan-id>".
Cajun DocServer
NOTE: Release notes for the Cajun DocServer incorrectly excludes mention of the P550 platform. Both the Cajun P550 and P220 platforms are supported.
DVRMP
NOTE: The Cajun P550R Switch may lose a small number of DVMRP neighbor-to- neighbor probe messages which may cause multicast routing instability under heavy loads.
Cajun P220, P550, P550R Switch Release Notes, Release 4.0.1 | 13 |