Lennox Hearth I200 manual Imprinter connector

Page 47

6.Attach and tighten the fourth thumbscrew on top of the circuit board mounting bracket.

7.Make sure that the imprinter board is seated and secure.

8.Tighten the three thumbscrews that connect the imprinter board and the circuit board mounting bracket.

9.Replace the circuit board cover.

10.Secure the circuit board cover with its two screws.

11.Locate the imprinter connector on the circuit board cover.

The imprinter connector should be protruding from the opening on top of the circuit board cover.

Imprinter connector

A-61167 April 2005

C-5

Image 47

Contents User’s Guide Contents Troubleshooting Using the ScannerAppendix D Kodak i200 Series Dockable Flatbed Introduction Scanner featuresSpeed/Capacity Throughput Paper transport featuresImage quality features MaintenanceOptional accessories Preparing documents for scanning Recommended documents User precautions Safety informationSafety and regulatory agency approvals Environmental information Acoustic emission Power system Taiwan EMC statementsUnited States JapanSite specifications Installing the ScannerSystem requirements Front Unpacking the scanner Registering your scannerScanner components Internal RearSide Making connections Power setup Page Page Tray extenders and side guides Page Continuous feeding Using the ScannerStarting and stopping scanning Automatic feeding Damaged documents Manual feedingSpecial Document mode Additional featuresLong Paper mode Toggle patch Perfect Page withIThresholding Cleaning the scanner MaintenanceCleaning the separator module Front roller cover Page Cleaning the imaging guides CAT No Replacing partsCleaning the paper path Click Calibrate Lamps Clearing document jams TroubleshootingIndicator lights Adjusting the separator module tension System is not responding Color image quality Problem Possible Solution Problem solvingProblem Possible Solution Transporting the scanner Appendix a Specifications Dimensions Power SourceScanner Dimensions Scanner WeightAppendix B Supplies and Accessories Appendix C Kodak i200 Series Imprinter Contents of the imprinter kit Removing the circuit board cover Installing the imprinterAttaching the imprinter board and cable Thumbscrews Hook Imprinter connector Page Page Completing the imprinter installation Page Installing the ink blotter strips Installing an ink cartridge Setting the imprinter position Imprinter maintenance Replacing the ink blotter strips Replacing Ink cartridge carrier Printable Character Set Print charactersImprinter specifications Appendix D Kodak i200 Series Dockable Flatbed Contents of the dockable flatbed kit Flatbed specificationsInstalling the dockable flatbed Remove the scanner front panel Book scanning Using the flatbedClick Calibrate Cleaning the flatbed After a power failure Removing the dockable flatbed Press firmly against the right side of the door to latch it Scanner Model Document Size Basic Memory Total Memory Appendix E Installing Optional MemoryInstalling memory in the scanner Circuit board cover Remove the existing memory card from the main control board Eastman Kodak Company