Lennox Hearth I200 manual Installing an ink cartridge

Page 53

Installing an ink cartridge

To install the ink cartridge:

1.Locate the imprinter access door on the back of the scanner.

2.Slide your fingers under the imprinter access door handle and pull the door toward you.

3.Lift the imprinter access door off the scanner.

4.Slide the ink cartridge carrier out of its position.

5.Raise the locking bar.

6.Remove the empty ink cartridge, if one is present.

NOTE: Dispose of empty ink cartridges properly. Do not incinerate ink cartridges.

7.Insert a new ink cartridge.

8.Lower the locking bar around the ink cartridge.

9. Slide the ink cartridge carrier into its position.

NOTE: You may change the ink cartridge carrier positions. Refer to the following section, “Setting the imprinter position.”

10. Replace the imprinter access door.

A-61167 April 2005

C-11

Image 53

Contents User’s Guide Contents Troubleshooting Using the ScannerAppendix D Kodak i200 Series Dockable Flatbed Introduction Scanner featuresImage quality features Paper transport featuresMaintenance Speed/Capacity ThroughputOptional accessories Preparing documents for scanning Recommended documents User precautions Safety informationSafety and regulatory agency approvals Environmental information Acoustic emission Power system United States EMC statementsJapan TaiwanSite specifications Installing the ScannerSystem requirements Front Unpacking the scanner Registering your scannerScanner components Internal RearSide Making connections Power setup Page Page Tray extenders and side guides Page Continuous feeding Using the ScannerStarting and stopping scanning Automatic feeding Damaged documents Manual feedingSpecial Document mode Additional featuresLong Paper mode Toggle patch Perfect Page withIThresholding Cleaning the scanner MaintenanceCleaning the separator module Front roller cover Page Cleaning the imaging guides CAT No Replacing partsCleaning the paper path Click Calibrate Lamps Clearing document jams TroubleshootingIndicator lights Adjusting the separator module tension System is not responding Color image quality Problem Possible Solution Problem solvingProblem Possible Solution Transporting the scanner Appendix a Specifications Scanner Dimensions Power SourceScanner Weight DimensionsAppendix B Supplies and Accessories Appendix C Kodak i200 Series Imprinter Contents of the imprinter kitRemoving the circuit board cover Installing the imprinterAttaching the imprinter board and cable Thumbscrews Hook Imprinter connector Page Page Completing the imprinter installation Page Installing the ink blotter strips Installing an ink cartridge Setting the imprinter position Imprinter maintenance Replacing the ink blotter strips Replacing Ink cartridge carrier Printable Character Set Print charactersImprinter specifications Appendix D Kodak i200 Series Dockable Flatbed Contents of the dockable flatbed kit Flatbed specificationsInstalling the dockable flatbed Remove the scanner front panel Book scanning Using the flatbedClick Calibrate Cleaning the flatbed After a power failure Removing the dockable flatbed Press firmly against the right side of the door to latch it Scanner Model Document Size Basic Memory Total Memory Appendix E Installing Optional MemoryInstalling memory in the scanner Circuit board cover Remove the existing memory card from the main control board Eastman Kodak Company