Wiring the CD Changer

DATA CABLE

The 15 foot data cable connects the changer to the FM module. First connect the end of the data cable labelled "TO CD CHANGER" to the socket on the left side of the changer. Route the other end of the cable up to the car’s dashboard area near your existing car radio and plug the data cable into the mating socket on the end of the FM module.

WIRING THE FM MODULE

The FM module should be positioned near your existing car stereo and the 15 foot data cable should be connected to it. Make the following connections to the FM module:

ORANGE WITH WHITE STRIPE WIRE

Attached to the FM module is a 3 foot orange with white stripe wire. This is to be connected to a + 12 volt circuit that is only live when the ignition is on. The best connection point is at the car’s fuse block at the “RADIO” or “ACCES- SORY” identified terminals.

FM MODULE

15 FOOT DATA CABLE

"TO CD CHANGER" LABEL

CAR FUSEBLOCK

"RADIO" OR "ACCESSORY" TERMINAL

FM MODULE

ORANGE w/WHITE

STRIPE WIRE

GREEN WITH WHITE STRIPE POWER WIRE

EXISTING +12 VOLT "LIVE" WIRE

12 VOLT

CAR BATTERY

The 3 foot green with white stripe wire must be connected toa “live” 12 volt wire in the vehicle. You will have to check the wire you connect it to and make certain it is always “live”’ even when the car’s ignition is turned off. If none is found, route the wire to the car’s fuseblock and connect it to a “live” circuit there.

GREEN w/WHITE

STRIPE WIRE

SPLICE INTO "LIVE" WIRE

AND TAPE SPLICE

FM MODULE

15 FOOT EXTENSION LEAD (MAY NOT BE REQUIRED)