OPERATING INSTRUCTIONS
Upon inserting a loaded CD magazine into the changer, the unit will begin automatically checking the magazine for the number of discs loaded and their locations. This will occur even if the vehicle’s ignition is turned off. This process will take approximately 45 seconds. During this time, the remote control function will be inoperative.
CONTROLS
1LCD Display
2Play/Pause ( 
/ II)
3Power Off Switch (OFF)
4Disc Select ( + - )
5Track Select ( 
)
6Track Search ( 
)
7Track/Disc Shuffle (SHFL)
8Track/Disc Repeat (RPT)
9Track/Disc Scan (SCN)
10Reset Button
PREPARING FOR OPERATION
1.Load CD magazine bm and insert into changer as described on page 16.
2.Turn on your car ignition and your car stereo bn and select “FM” band bo.
3.Tune to 89.1 on the FM band bp unless you set the selection switch on the FM module to 88.7; then
tune to 88.7 on the FM band.
1 |
|
| 4 |
| 2 |
| DISC SELECT |
INTRO SCAN |
|
9 | 8 |
SHUFFLE | POWER |
7 | 3 |
10 | 5 | 6 |
|
|
11
14
13
Note: You may find that it will be easier to use one of your presets specifically for CD operation.
4. | Depress the “RESET” button bq on the remote |
| control. |
| Note: This is only required the First Time you use |
| the Changer. |
5. | Turn on the CD player by pressing the Play/Pause |
| button br. The CD panel bswill illuminate and disc |
| number 1 will begin play. |
6. | Adjust your car radio’s volume, balance and tone |
12
FM 89.1
17
16
controls for desired sound. |
7. When the last track on disc 1 has played, the unit |
INTRO SCAN | REPEAT |
SHUFFLE
will automatically advance to the next disc in |
sequence and begin playing. This will continue |
until all discs have been played at which time the |
unit will begin playing disc number 1 again. |
15
SHFLOFF
13