Installation

The unit can be installed horizontally, vertically or at a 45° angle. The position of the built-in anti-vibration springs (lef t and right side), must correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration compensation will not be effective and vibration may cause the disc to skip.

CAUTION: After setting the built-in anti-vibration springs, place the supplied Seals (B) over the holes. These seals are used to keep dust, which could cause a malfunction, out of the unit.

HORIZONTAL INSTALLATION Set the left and right anti-vibration springs to position "H".

position "H"

45	H
45
V

VERTICAL INSTALLAITON

Set the left and right anti-vibration springs to position "V".

V	45
position "V"	H

45° ANGLE INSTALLATION Set the left and right anti-vibration springs to position "45°".

position "45°"

	4
V	5	H
V

45°

PROCEDURE FOR HORIZONTAL INSTALLATION

Attach bracket (L) and bracket (R) to each side of the unit, using the hexagonal bolts with washer base (M5 x 10)

A n t i - v i b r a t i o n

H 45	springs position
V	springs position	45	H
		V
			Bracket (L)

NOTE: Use seals (A) to cover unused
mounting holes on sides of unit.		Hexagonal bolt (4)
	Bracket (R)	Hexagonal bolt (4)
	Bracket (R)	with washer base (M5 x 10)
		with washer base (M5 x 10)

Determine the mounting location, and drill four mount- ing holes.

Never mount the unit near the fuel tank.

Drill holes 4mm in diameter.

3 Secure the unit in place, using four self-tapping screws (M5 x 12).

Use RTV (silicone sealer) on screw threads or around the holes to prevent moisture intrusion.

Bracket (L)

Self-tapping screw (M5 x 12)

Bracket (R)