Audiovox ACC-52 owner manual Overall Wiring View

Page 9

OVERALL WIRING VIEW

This page is provided to give you a quick look at the entire wiring of the ACC-52. Use it to plan your wire routing paths and possible connection points. Detailed wiring is explained in the following pages.

EXISTING CAR

RADIO ANTENNA

CABLE

ANTENNA INPUT

 

ANTENNA OUTPUT

EXISTING CAR RADIO

ANTENNA SOCKET

EXISTING CAR

STEREO

FM MODULE

GREEN/WHITE POWER WIRE CONNECT TO SOURCE OF CON-

STANT +12 VOLTS

BLACK

GROUND WIRE

ORANGE/WHITE

WIRECONNECT TO THE CAR'S FUSEBLOCK AT THE "RADIO" OR "ACCESSORY" IDENTIFIED TERMINALS

DATA CABLE (15 FEET)

REMOTE CONTROL

REMOTE CONTROL

CABLE (4-1/2 FEET)

NOTE: When routing wires and cables

from the rear of the car to the dash-CHANGER board, it is best to conceal the wires

under carpeting. If you do not know how to do this, your local auto me- chanic or car stereo installer should be consulted.

9

Image 9
Contents Model ACC-52 REMOTE-CONTROL Disc CD Changer Introduction Installation Parts Other AccessoriesMain Unit Additional 10-DISC Magazines Before Installing the UnitTrunk Mounting Sedans Where to Install the ChangerHATCHBACKS, Wagons & Vans Under PASSENGER’S Front SEAT/BEHIND SeatProcedure for Horizontal Installation InstallationProcedure for Vertical Installation Procedure for 45 Angle Installation Overall Wiring View Wiring the CD Changer Orange with White Stripe WireGreen with White Stripe Power Wire Remote Control Cable Black Ground WireCAR Antenna Input Radio Antenna OutputMounting the FM Module Mounting the Remote ControlPreparing for Operation ControlsLCD Display USE of ControlsHandling the Discs Hints for Correct and Safe OperationLoading Discs Into the Magazine USE of the CD MagazineChanger CD Changer Operating Instructions SpecificationsSymptom Possible Cause Remedy TroubleshootingMonth Limited Warranty Audiovox Electronics Corp., Hauppauge, NY