BEFORE INSTALLING THE UNIT
Transport Lock Screws
TRANSPORT LOCK SCREWS (2 RIGHT SIDE, 1 LEFT SIDE)
The mechanism in the CD changer is "locked" into place during shipment by the transport screws. Be sure to remove the screws prior to installation.
l Caution l
After removing the transport lock screws, place the supplied seals (A) over the screw holes. These seals are used to keep dust out of the unit, which could cause a malfunction.
45 V
H
Installation and Wiring Precautions
1 To prevent a
lBe sure to turn off the ignition and remove the negative
lConnect power wires last.
Note
If the changer is to be installed in a car that is equipped with an
2 | Do not install the unit in the following locations. |
| l Locations exposed to direct sunlight. |
| l Where hot air is discharged from the car heater. |
| l In areas subject to extreme temperatures. |
3 | Incorrect installation can cause the sound to "skip" when playing a disc. |
| Mount the unit firmly in place, using the supplied brackets and screws. |
4 | Be careful not to damage the car wiring. |
5 | l Be sure to use the supplied screws. |
| l Be careful not to snag any wires when tightening screws. |
| l Do not use any of the screws that are part of the brake or steering system, to install the unit. |
6 | l This unit cannot be installed on its side, end, or upside down. Installation in such positions will cause malfunctioning |
| of the mechanism. |
ADDITIONAL 10-DISC MAGAZINES
Additional CD magazines are available as an accessory item (Part No.
Audiovox Corp.
150 Marcus Blvd. Hauppauge, N.Y. 11788 Attn: Parts Department
NOTE: New York residents, please include applicable sales tax.
4