NOTE
The AVR600 provides power for the Sirius receiver, so an external power supply is not needed.
English
FM
Connecting an aerial
|
|
|
| A suitable FM aerial must be |
|
|
|
| connected to the AVR500/ |
SIRIUS |
|
| FM | AVR600 before FM radio can be |
|
|
|
| received. |
rLead/rDock |
|
| AM | In strong signal areas, the FM |
|
| ribbon aerial supplied can be | ||
|
|
| ||
|
|
|
| used with reasonable results. |
|
|
|
| Mount this as high up as possible |
|
|
|
| on a wall with the top of the |
‘T’‑elements positioned vertically or horizontally, depending on the reception in your area. Try each usable wall of the room to see which gives best reception and use tacks or adhesive tape to secure the aerial, but note that no tacks should come into contact with the internal wire of the aerial.
When installed and receiving FM radio, check the signal strength by pressing the front panel or remote control’s INFO button until the signal indicator is displayed.
In weak signal areas, or for optimal FM radio reception, a roof- or
In some areas, cable radio may be available or, in an apartment building, a distributed aerial system may be installed. In either of these cases you should have sockets in your home marked FM or VHF (do not use those marked TV); these should be connected to the FM coaxial connector on the rear of the AVR500/AVR600.
AM
Connecting an aerial
SIRIUS
rLead/rDock
FM
AM
An AM aerial is required to receive AM/medium wave radio signals, so a simple loop aerial is supplied with the AVR500/ AVR600. Follow the assembly instructions in the diagram below.
Make sure that the aerial is
positioned well away from the AVR500/AVR600 itself, TVs,
computers and other sources of RF ‘interference’. Rotate the aerial to discover which position gives the best reception.
1. Release the |
| 3. Connect the lead wires to the AM socket | |
2. Push the tab into the open slot in the | at the rear of the AVR600 (the wires are | ||
twisted lead. Fold the plastic stand | |||
not polarised). Rotate the aerial’s stand | |||
forward through the loop frame. | base of the stand. Press until the tab | ||
until you obtain the best reception. | |||
| clicks home. | ||
|
|