Arcam AV888 front panel operation, E-27, English, Input, Mode, Display, Info, Power / Standby LED

front panel

operation

Input

These buttons select the source connected to the corresponding input (or internal input)

Unused sources can be prevented from being selected in the setup menu.

Direct

Mode

Stereo Direct on/off. Provides a direct analogue path from

the analogue inputs to the left and right front outputs.

Switches off any surround processing modes and shuts

Selects between Stereo and the available

surround modes for the current source.

down the DSP circuits for best stereo sound quality.

Display

Info

This switches the display brightness

Selects the information displayed on the

between off/dim/bright.

lower left portion of the front panel.

OK

Zone

Power / Standby LED

Selects between Zone 1, Zone 2 and

Used to enter selections made in the

This indicates the status of the AVR500/AVR600/

Zone 3 control.

Setup menu. Also forces the analogue

AV888. When first turned on, the LED is orange,

and digital video outputs to the default

Mute

to indicate that the unit is ‘initialising’; this

resolution: 480i (525-line NTSC) when

changes to green when fully powered and ready.

Mutes all analogue audio outputs in the

pressed for more than 2 seconds.

Red indicates that the unit is in Standby mode.

currently selected zone.

POWER/STANDBY

Volume

Adjusts the analogue output

volume in the selected zone

MENU

Ð INPUT +

OK

INFO MODE

DIRECT DISPLAY ZONE MUTE

Ð VOLUME

+

(line out, speakers and

headphones).

Power

AVR600

V I D E O S C A L I N G

Switches the main power to the

AUX

PHONES

POWER

AVR500/AVR600/AV888 on

and off.

Once the unit is switched off,

it should be left for at least ten

seconds before switching on

again.

Aux

Phones

Multi purpose auxiliary

This socket accepts headphones

line level input,

with an impedance rating between

Remote control receiver. This is positioned behind

calibration microphone

32Ω and 600Ω, fitted with a 3.5mm

Menu

the display window, above the MENU button on the

input and 3.5mm optical

stereo jack plug.

front panel. Ensure the receiver is in a clear line of

digital (SPDIF) input.

Selects the Setup menus on the

sight from the remote control for operation. If this is

on-screen display (OSD).

not possible, use a separate sensor connected to the

Z1 IR input on the rear panel.

E-27

English