Intellinet Network Solutions 523431 manual

Page 12

8.Click ”Start” —> “Run.”

9.Input ”cmd”; then click “OK.”

10.Input “ipconfig” in the pop-up command window.

NOTE: Make sure your IP is the same that listed below. If it’s the same, then your configuration is successful. If not, redo the above steps and restart your computer.

The IP address is between 192.168.0.2 and 192.168.0.254

The subnet mask is 255.255.255.0

The default gateway is 192.168.0.1 (the router’s default IP address)

12

Image 12
Contents INT-523431-UM-1106-01 Table of Contents Specifications IntroductionSwitch ports, auto sense cross cable Wireless Frequency 412 -2.472 GHzOne 10/100 Mbps RJ-45 port, automatic External Sense cross cable PortsData ModulationControl Based on Web application Interface Upnp Gateway Virtual server QoS & VPN serverBefore Installation Installation2MB Flash MemoryPower LED Long light LED flashes on-off-on-off during normal Description ExplanationLAN Connect personal computers, hubs or switches Antenna Power Port LAN 1 ~ ResetWindows 2000 Setup Connect xDSL/cable modem or LAN cablePage Page Page Page Windows XP Setup Page Page Page Router Setup Start Internet Explorer to LogPPPoE Configuration Page Page Other configuration options of the PPPoE WAN setup screen Page Page Other configuration options Static IP ConfigurationPage Status WAN Status Click Status WAN StatusWireless Status Click Status Wireless StatusLAN Status Click Status -LAN StatusBasic Setup 4.6.1 WAN Setup Wireless Setup Region Configure the region depending on your location Reject mode Specified client can not connectLAN Setup Click Basic Setup LAN/DHCP SetupSystem IP Setup Click Basic setup Link Setup/Info Link Setup Link Information Routing Table for advanced users onlySystem Administrator Setup Firmware Upgrade Upgrade procedurePage System Log Click System System logMiscellaneous Configurations Config Mgmt/RestartPage QoS Basic Setup IP QoSClick QoS IP QoS Application QoS Click QoS Application QoSPorts QoS Click QoS Port QoSNAT Applications Click NAT ApplicationsSetup Method Application Port Internal Server Click NAT Internal ServerProtocol Server Port Forwarding Rule Name Shiii TCP Protocol TCPPort Trigger NAT On/Off Advanced Setup Firewall Ddns Click Advanced Ddns as followsWOL Wake-on LAN Click Advanced WOLURL Filter Click Advanced URL FilterRemote Management VPN Setup Click Advanced VPN SetupExample http//123.456.7898081 remote management port set to SchedulerSetup Method Appendix a UTP Cable Specifications Straight-through Cable Crossover CablePage
Related manuals
Manual 4 pages 43.38 Kb